Description
Maximum disruptive effect with short pimples
This is now the fifth variant of our very successful KILLER series.
KILLER EXTREME is primarily a further development of the KILLER PRO. It has managed to further enhance the disruptive effect achieved by blocking, counterattack and smashing. The ball noticeably pulls down in almost all phases of the game, causing problems and even direct errors.
This makes KILLER EXTREME one of the most dangerous short pimple rubbers on the market.
The faster bottom layer also allows you to build even more pressure in active play to earn points more easily with active counterballs and with a smash.
The best compromise between control and disruptive effect is achieved with thinner substrate thicknesses (1.3 and 1.5 mm). With a thicker underlayer, the surface becomes faster, but has a slightly less disturbing effect.
The underlayer is pre-coated with glue. Apply an extra thin layer of water soluble table tennis glue to the surface and a regular layer of glue (also water soluble) to the frame, then let it dry for 10-15 minutes.
Finally, carefully roll the rubber onto the frame and cut off the protruding part
Speed: 102
Spin: 80
Control: 88
Hardness: Soft
This is now the fifth variant of our very successful KILLER series.
KILLER EXTREME is primarily a further development of the KILLER PRO. It has managed to further enhance the disruptive effect achieved by blocking, counterattack and smashing. The ball noticeably pulls down in almost all phases of the game, causing problems and even direct errors.
This makes KILLER EXTREME one of the most dangerous short pimple rubbers on the market.
The faster bottom layer also allows you to build even more pressure in active play to earn points more easily with active counterballs and with a smash.
The best compromise between control and disruptive effect is achieved with thinner substrate thicknesses (1.3 and 1.5 mm). With a thicker underlayer, the surface becomes faster, but has a slightly less disturbing effect.
The underlayer is pre-coated with glue. Apply an extra thin layer of water soluble table tennis glue to the surface and a regular layer of glue (also water soluble) to the frame, then let it dry for 10-15 minutes.
Finally, carefully roll the rubber onto the frame and cut off the protruding part
Speed: 102
Spin: 80
Control: 88
Hardness: Soft